The LiteOn FlexFi Indoor is a commercial 4T4R O-RAN 7.2 radio unit for band n78 with no M-Plane: it runs from settings
stored in the radio and set through its command-line interface. It is the only COSMOS O-RU that all three frameworks
drive end to end: OCUDU and Duranta at 100 MHz, Amarisoft at 30 or 60 MHz (licence limit). OCUDU's and Duranta's
layer 2 on the NVIDIA Aerial layer 1 also work with it. OCUDU and Duranta need the same radio state, so it is the easiest O-RU to
share between frameworks.
| Item | Value |
|---|---|
| Vendor / model | LITEON FlexFi Indoor, FF-RFI078I4, firmware 02.00.10 |
| Band / tuning range | n78, 3300–3800 MHz |
| Maximum bandwidth | 100 MHz (273 PRB at 30 kHz) |
| Antennas | 4T4R |
| M-Plane | none; configured over its CLI by the bring-up scripts (port 830 is a stub, not a NETCONF server) |
| Compression | block floating point, 9 bits, static header (DL, UL and PRACH) |
| Fronthaul MTU | jumbo frames; the radio's jumbo-frame setting is volatile and must be re-applied after every boot |
| PTP | G.8275.1, domain 24 |
| Power setting | TX attenuation 17, RX attenuation 14; maximum TX power not recorded |
OCUDU. The radio's stored configuration fits OCUDU, which has no NETCONF client. The DU drives all four DL ports
(dl_port_id: [0, 1, 2, 3]), PRACH index 159 with four contention preambles, ta4_max 1960 µs and
max_proc_delay 10. The packaged tutorial is
OCUDU over a commercial O-RU.
Duranta. Duranta uses its static (non-M-Plane) fronthaul library, TDD DDDSU with a 6:4:4 special slot, PRACH
index 159 and att_tx 0. As on the Benetel, the image keeps four DL layers only where the DU gets at least 20 CPUs.
The packaged tutorial is Duranta over a commercial O-RU.
Duranta's layer 2 on the NVIDIA Aerial layer 1 also works with this radio
(Aerial with commercial O-RUs), as does OCUDU's
(OCUDU on NVIDIA Aerial).
Amarisoft. lteenb with its trx_s72 driver works with the LiteOn. The COSMOS licence allows cell bandwidth ×
antennas ≤ 120 MHz, so the cell is 30 MHz 4T4R or 60 MHz 2T2R; 100 MHz runs only 1T1R. The tutorial is
Amarisoft over O-RAN 7.2.
One UE, iperf3 receiver line, Mbit/s. UDP is the highest rate with less than 5 % loss.
| Framework | CPU platform | DL TCP | DL UDP | UL TCP | UL UDP | Date(s) | Build / image |
|---|---|---|---|---|---|---|---|
| OCUDU | 2× Intel Xeon Gold 6226 (24C/24T) | 195 | not measured | 140 | not measured | 2026-09-14 | ocudu-20260909b |
| OCUDU | 2× Intel Xeon Gold 6126 (24C/48T) | 208 | not measured | 76 | not measured | 2026-09-22 – 2026-10-05 | ocudu-20261005b (DL), ocudu-20260916 (UL) |
| OCUDU | 1× AMD EPYC 9355P (32C/32T) | 155 | 751 | 146.9 | 166.3 | 2026-09-14 – 2026-10-23 | ocudu-20260909b (TCP DL), ocudu-main-20261020 (UDP DL), ocudu-20261020 (UL) |
| Duranta | 2× Intel Xeon Gold 6226 (24C/24T) | 202 | not measured | 46.9 | not measured | 2026-09-14 | duranta-20260907c |
| Duranta | 2× Intel Xeon Gold 6126 (24C/48T) | 234 | not measured (no point below 5 % loss) | 42.5 | 48.3 | 2026-09-27 – 2026-10-19 | duranta-w42-20261019 (TCP), duranta-20260927 (UDP UL) |
| Duranta | 1× AMD EPYC 9355P (32C/32T) | 299 | 612 | 49.0 | 47.9 | 2026-10-20 – 2026-10-25 | duranta-w42-20261019 (TCP), duranta-w42-20261021 (UDP DL), duranta-w43-20261024 (UDP UL) |
| OCUDU + NVIDIA Aerial L1 | NVIDIA GH200 | 190 | not measured | 26 | not measured | 2026-11-09 | aerial-26-2-gh200 (Aerial 26-2); LiteOn at 3350.01 MHz |
| Duranta + NVIDIA Aerial L1 | NVIDIA GH200 | 472–487 | not measured | 56.8 | not measured | 2026-11-04 | aerial-26-2-gh200 (Aerial 26-2, Duranta 2026.w44) |
| Amarisoft | 2× Intel Xeon Gold 6226 (24C/24T) | not measured | |||||
| Amarisoft | 2× Intel Xeon Gold 6126 (24C/48T) | 344–349 (60 MHz 2T2R) | not measured | 12 | not measured | 2026-10-11 | amarisoft-20261009 (lteenb 2026-09-11) |
| Amarisoft | 1× AMD EPYC 9355P (32C/32T) | 329 (60 MHz 2T2R) | 360 | 20.9 | 22.0 | 2026-10-20 – 2026-10-23 | amarisoft.ndz (lteenb 2026-09-11) |
SYNCHRONIZED. At MTU 1500 it drops out of sync under load.Sync State : SYNCHRONIZED before starting the DU; a plain search also matchesNOT_SYNCHRONIZED.att_tx 35) leaves the cell 35 dB too weak; each O-RU needs its ownRX_ON_TIME, TX_TOTAL, DuConnected) are not health signals on this firmware; judge byAuthor(s): COSMOS team · Last reviewed: 2026-11-07 · Tags: cellular-4g5g-oran, oran